Search found 8 matches

by Pieter
Tue Nov 17, 2015 3:21 pm
Forum: Software/Firmware
Topic: Mac users - please raise your hand...
Replies: 64
Views: 18189

Re: Mac users - please raise your hand...

my pc just dropped dead a few days ago, now I'm trying to get repetier host going on my mac, and it's a nightmare. http://www.felixprinters.com/downloads/software/Repetier-Host-Mac_0_56.dmg has to be configured manually, and I could get skeinforge set-up, but it's a joke compared to what I got on my...
by Pieter
Fri Jul 24, 2015 2:30 pm
Forum: Other filaments
Topic: formfutura flexifill print
Replies: 1
Views: 1336

formfutura flexifill print

Does anyone use formfutura flexifill to print? I tried to print a piece (5x10cm, small touching edges to the bed, rounded edges) I'm printing on glass (sprayed with a water/woodglue sollution). Printing the same model with PLA works fine. The flexifill piece starts to come off of the bed at the corn...
by Pieter
Sat May 30, 2015 10:15 am
Forum: FELIXprinters.com feedback
Topic: forum search reults
Replies: 1
Views: 1037

forum search reults

When I do a search on the forum, I only can view the first page of results. It isn't possible to go to the next pages. I use chrome/safri on a mac. Does anyone has this problem?
by Pieter
Fri Jun 13, 2014 1:54 pm
Forum: Assembly
Topic: mounting Z-axle rail - step 15
Replies: 4
Views: 757

Re: mounting Z-axle rail - step 15

ok thank you!
by Pieter
Fri Jun 13, 2014 1:31 pm
Forum: Assembly
Topic: mounting Z-axle rail - step 15
Replies: 4
Views: 757

Re: mounting Z-axle rail - step 15

ok thx!
It's a bit confusing with the reflections. (& in step 28 there seems to be no space left)
by Pieter
Fri Jun 13, 2014 11:11 am
Forum: General
Topic: printer freezes when opening/closing light switch
Replies: 12
Views: 1795

Re: printer freezes when opening/closing light switch

Hugues,
did you allready try the filter?
by Pieter
Fri Jun 13, 2014 11:08 am
Forum: Assembly
Topic: mounting Z-axle rail - step 15
Replies: 4
Views: 757

mounting Z-axle rail - step 15

just started mounting my 3.0
step 15 of the manual says "10mm between plastic and rail", is this right???
In the drawing the rail seems to touch the plastic of the motor bracket.
by Pieter
Thu Jun 05, 2014 7:56 pm
Forum: General
Topic: printer freezes when opening/closing light switch
Replies: 12
Views: 1795

Re: printer freezes when opening/closing light switch

Guess this (or similar) could help you out: http://www.conrad.com/ce/en/product/530224/TE-Connectivity-6609006-9-Suppression-Filter-6609006-9-2-x-465-mH-6-A?ref=searchDetail (a gridfilter or RLC circuit. removes parasites from your powergrid) I used to have some troubles with electronic dimmed light...

Go to advanced search