Search found 4 matches

by Tomas
Sun Feb 01, 2015 3:37 pm
Forum: Troubleshooting
Topic: Brand new table bent out of the box
Replies: 2
Views: 645

Re: Brand new table bent out of the box

Let me rephrase that, the new parts I did not get to print with, the original parts worked long enough to get a couple minor jobs done before every time was a catastrophic failure. No amount of table leveling or calibration will fix it, It's quite distressing.
by Tomas
Sun Feb 01, 2015 3:10 pm
Forum: Troubleshooting
Topic: Brand new table bent out of the box
Replies: 2
Views: 645

Brand new table bent out of the box

Hi, I posted on these forums about 7 months ago and never got a reply from support or anyone. Firstly, I bought the Felix 3.0 printer back in june of last year and have had non-stop issues with it. Heater Cartridge and Z-Axis motor both failed and then the printing bed ended up bent and will not rec...
by Tomas
Sat Sep 13, 2014 8:22 pm
Forum: Troubleshooting
Topic: Heater Cartridge Failure, Z-Axis Motor Failure...
Replies: 0
Views: 707

Heater Cartridge Failure, Z-Axis Motor Failure...

Hi, I posted this before in early July and waited patiently for a response, possible that it was in the wrong forum section, IDK: http://forum.felixprinters.com/viewtopic.php?f=11&t=1006 Anyway, I was forced to source down another supplier for the Heater cartridge considering the one shipped out to ...
by Tomas
Sun Jul 13, 2014 2:03 am
Forum: Electronics
Topic: Just finished assembly, Cartridge heater failure.
Replies: 2
Views: 1801

Just finished assembly, Cartridge heater failure.

Hi guys, I just purchased a single extruder 3.0 felix and completed assembly last night, during calibrations I discovered the cartridge heating element is broken. I have run a series of tests with a multimeter and it is recieving electricity with no resistances but simply refuses to heat when I acti...

Go to advanced search