pozzy wrote:Hi neilv,

I originally bought a FELIX 2 then upgraded to a FELIX 3 via the upgrade kit. The main board stayed the same but the Power Supply was part of the upgrade along with some stop sensors. I hope this helps you.

Regards Glen

Ok thank you

After consulting with felix I send my 3.0 mainboard to them.
Yesterday i received another board but this was not the same type, it's a (used) 2.0?
this is a problem when i install it on a 3.0 printer?

This week, the mainfan and aiductfan not work. The result is that all the prints fail, because the filament get stuck. Fan optional no load 12,39V load 1,3V Fan main no load 0.135 Fan Head no load 9.98V load 9.98V Does anyone know how this (for the 2nd time) is possible? fans are working properly co...

When I print something, the print is smaller than what it should be. When I draw a circle of 40 mm than its actually 39.48 mm (printed) a gap of 7.8 mm is in fact 7.45 mm. Can anyone tell me what I'm doing wrong? Best bet is to check calibration of all axis + extruder, then perform a thin wall cali...

Great! Thanks

Thanks i gonna take a look in the firmware.

When I print something, the print is smaller than what it should be.
When I draw a circle of 40 mm than its actually 39.48 mm (printed)
a gap of 7.8 mm is in fact 7.45 mm.


Can anyone tell me what I'm doing wrong?

I've bought the Teflon tube from Zennix and it works perfectly !! this should be standard!!

two weeks ago a new board was send to me, finally i swapped it and everything works fine!!!
Thanks for the great service Felix.

Hi, I've got the same problem... my extruder fan output is not working. the prints failed because of PLA stuck Without load the output is 12V.When i measuring the voltage with load it's below 5V. At the moment i use a sepret 12v adapter to power it, but this is not something i want to do forever. I ...