Search found 5 matches

by emdash
Wed Jan 07, 2015 8:01 pm
Forum: General
Topic: extruder temperature sensor
Replies: 2
Views: 3047

Re: extruder temperature sensor

Have you turned on the logging window? Start by turning thta on. Then turn off all the extraneous information except for Error and Warning. If the temperature sensor is faulty, at some point you will see that the thermistor and heater have "decoupled", which will cause the printer to go into Dry Run...
by emdash
Sun Jan 04, 2015 3:14 am
Forum: Tips and Tricks
Topic: Common problems/Tips and tricks
Replies: 91
Views: 59754

Re: Common problems/Tips and tricks

I clean the bed with rubbing alcohol (70%), myself. It seems to do the job of removing the smudges from my grubby fingers. Acetone is over-kill.
by emdash
Sun Jan 04, 2015 2:17 am
Forum: General
Topic: PVA Glass in Extruder
Replies: 5
Views: 676

Re: PVA Glass in Extruder

Any luck?
by emdash
Sun Jan 04, 2015 1:34 am
Forum: General
Topic: What happened with Make review?
Replies: 3
Views: 836

Re: What happened with Make review?

When I first assembled my 3.0, I had some issues with the X-axis pulley coming loose. This was basically caused by the set screw backing out gradually. Eventually I was able to get the right torque on the set screw where it doesn't come loose like that. I wonder if that was the issue they had.
by emdash
Sun Oct 26, 2014 6:00 pm
Forum: Assembly
Topic: Felix 3.0 Step 21 Z-Axis Lift Part doesn't fit (solved)
Replies: 6
Views: 2013

Re: Felix 3.0 Step 21 Z-Axis Lift Part doesn't fit (solved)

I am having the same issue. If you have some pictures of how you modified the part, I would appreciate it. Did you have any subsequent assembly issues after this?

Go to advanced search