Search found 6 matches

by Jaanus
Sun Jan 11, 2015 8:33 am
Forum: General
Topic: Extruder v4 faillure, resolving the issue with E3D v6!!
Replies: 17
Views: 4741

Re: Extruder felix V3 extreme leakage...

See some tips in this topic, I had same situation when I tryied to print ABS while ago now I'm working in new solution of extruder so that the PEEK part is not an issue anymore. Meanwhile I have to make some more parts to stock when it's ready ;) Here You can find some 3D parts for extruder which I ...
by Jaanus
Sun Jan 11, 2015 8:25 am
Forum: General
Topic: Opto sensors
Replies: 8
Views: 3706

Re: Opto sensors

Same trouble in here, none of 3 opto sensors does not work anymore, LEDs doesn't light at all. Only X axis goes to home, doesn't matter that opto does not work, it goes anyway, but any other axes (X and Y) moved to home by me :)
by Jaanus
Sat Jan 10, 2015 7:33 am
Forum: General
Topic: Hot-end isolation peek gets melted
Replies: 1
Views: 2851

Re: Hot-end isolation peek gets melted

Just change that PEEK part for new one and it works well again but, how many workhours Your machine run before PEEK melted up? I had same experience about month ago and I figured out that the period is bit shorter than PEEK's manufacturer says, something like that: "Constant Temperature min . 20,000...
by Jaanus
Fri Jan 02, 2015 10:30 pm
Forum: Tips and Tricks
Topic: Common problems/Tips and tricks
Replies: 91
Views: 60013

Re: Common problems/Tips and tricks

Why the filament does not stick onto bed? Just clen it with acetone when it 40...50 degrees - I clean the bed once after 4 or 8 printing time and I do not have any problem with not-sticking. Also I found that I do not have to change kapton so often at all - 1 roll for year is quite enough. :)
by Jaanus
Fri Jan 02, 2015 10:25 pm
Forum: Tips and Tricks
Topic: Common problems/Tips and tricks
Replies: 91
Views: 60013

Re: Common problems/Tips and tricks

Guys, I think that I found the main reason for this trouble. I had also this kind on trouble and I found the solution for this trouble - I had none of this kind of trouble anymore, at all. So, when the hot-end heats up the nozzle then the hole in PEEK insulation getting smaller. I think that it has ...
by Jaanus
Fri Jan 02, 2015 10:07 pm
Forum: Troubleshooting
Topic: Printer stops during printing
Replies: 3
Views: 1066

Printer stops during printing

I bought 2.0 since year ago and now I have a problem with it - let's say it is big issue :) During printing at long time - let's say that over 2 or more hours, it just stops physicly. All of the steppers are stopped but software shows that it runs still. All day long, today, I read from forum and tr...

Go to advanced search