Search found 45 matches

by aikx
Tue Nov 27, 2012 6:56 pm
Forum: Electronics
Topic: Stepper driver dead....
Replies: 12
Views: 3545

Re: Stepper driver dead....

satoer wrote:Have you installed firmware version RC3?
I can´t find this version! Any hints?
by aikx
Sun Nov 18, 2012 9:04 pm
Forum: General
Topic: Major help needed - Multiple issues!!
Replies: 31
Views: 4463

Re: Major help needed - Multiple issues!!

Same problems without LCD / SD controller and "un-tweaked" Marlin?
by aikx
Sun Nov 18, 2012 7:59 pm
Forum: General
Topic: Major help needed - Multiple issues!!
Replies: 31
Views: 4463

Re: Major help needed - Multiple issues!!

What is the firmware you use? Marlin? The modified Felix-Version?
by aikx
Tue Nov 06, 2012 10:32 am
Forum: General
Topic: Felixprinter 1.5: Pictures, Problems, Solutions and upgrades
Replies: 24
Views: 13005

Re: Felixprinter 1.5: Pictures, Problems, Solutions and upgr

@ Satoer: After finishing the 1.5 Upgrade, optimizing the Z-axis an calibrating i printed your filament holder (SFact, Normal Quality). Simple and effective solution!! (the printed diameter was about 26mm, added some tape over the tube) @ gfeliksdal: 1.5 Upgrade is the right step. Together with sato...
by aikx
Tue Nov 06, 2012 10:18 am
Forum: Software/Firmware
Topic: Mac users - please raise your hand...
Replies: 64
Views: 18549

Re: Mac users - please raise your hand...

concar wrote:Question: generated gcode on mac also work on pc when loaded directly?
I can use Guillaume´s "PC"-gcode on Mac. Should work vice versa.
by aikx
Wed Oct 31, 2012 9:51 am
Forum: General
Topic: Felixprinter 1.5: Pictures, Problems, Solutions and upgrades
Replies: 24
Views: 13005

Re: Felixprinter 1.5: Pictures, Problems, Solutions and upgr

Later I discovered you could maybe move the Z-axis slider away from the X-axis motor (horizontally, towards front of the printer) making room for the shaft. There's some play between the slots in the aluminum extrusions and mounting bolts of Z-slider. Be carefully with this! Moving the Z-axis to th...
by aikx
Tue Oct 30, 2012 8:16 pm
Forum: General
Topic: My first 3D printer
Replies: 30
Views: 7263

Re: My first 3D printer

15 minutes with power cord not connected and now she works again! :o Is this common?
No! Never!
EDIT:
I tried plugging in and out the power cord but nothing.
Remove power cord AND USB cable to reset arduino.
by aikx
Fri Oct 26, 2012 12:26 pm
Forum: General
Topic: My first 3D printer
Replies: 30
Views: 7263

Re: My first 3D printer

However, I do find the Z axis movement annoying, especially the Z axis slider. I cannot really tighten the bolts connecting the printed parts and the slider, as then it just binds up.
Use 2 or three washers under the bolts to avoid blocking.
by aikx
Sat Oct 06, 2012 10:33 am
Forum: Hacks and printer upgrades
Topic: WIP: Dual extruder
Replies: 35
Views: 8055

Re: WIP: Dual extruder

linear ball bearing guides from hiwin
Open Type?

Go to advanced search