Mechanics

Discussions about mechanics
New Topic
  • Topics
    Replies
    Views
    Last post
  • X Axis Motor Bracket
    by [email protected] »
    0 Replies
    1225 Views
    Last post by [email protected]
  • Disassembling hot end?
    by dext0rb »
    3 Replies
    1052 Views
    Last post by dext0rb
  • Trouble with leveling bed / table
    by retsac »
    3 Replies
    1523 Views
    Last post by Kohderek
  • When Should the 2 Small Vertical Fans go?
    by tekadept »
    5 Replies
    1401 Views
    Last post by tekadept
  • Y-Motor heat causes table rise
    by d.herrendoerfer »
    2 Replies
    894 Views
    Last post by d.herrendoerfer
  • Dual filament unwind stopper
    by d.herrendoerfer »
    0 Replies
    693 Views
    Last post by d.herrendoerfer
  • Opto-sensor does not work!
    by Landsteiner »
    9 Replies
    2377 Views
    Last post by Saamec
  • Filament ball bearing
    by alanh »
    0 Replies
    711 Views
    Last post by alanh
  • can the printer be upgraded to use 3mm filament ?
    by mbx125 »
    2 Replies
    1498 Views
    Last post by satoer
  • Dual pinch wheel extruder on Indiegogo
    by Hugues »
    2 Replies
    1119 Views
    Last post by kimmoli
  • Excessive Chatter on Z Axis Movement
    by seaton »
    4 Replies
    1733 Views
    Last post by dognotdog
  • Blowing direction of horizontally mounted fan
    by hoolito »
    1 Replies
    717 Views
    Last post by Makron
  • where to buy online the M6 T-slot nuts ?
    by Hugues »
    3 Replies
    2043 Views
    Last post by angryangel
  • Fanduct
    by bigboerner »
    2 Replies
    1611 Views
    Last post by bigboerner
  • Y-Motor pushes through Y-OptoSensor
    by evanr »
    14 Replies
    4222 Views
    Last post by satoer
  • Problem with frame dimensions
    by aussieW »
    2 Replies
    1920 Views
    Last post by aussieW
New Topic

Return to Board Index

Forum permissions

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum