General

General discussions regarding hardware
New Topic
  • Topics
    Replies
    Views
    Last post
  • Extruder Stepper bug
    by TBaden »
    1 Replies
    2636 Views
    Last post by frankjoke
  • Extruder v4 faillure, resolving the issue with E3D v6!!
    by Eli-Audio »
    17 Replies
    4688 Views
    Last post by alanh
  • 3d printed object smaller than drawing
    by neilv »
    7 Replies
    3834 Views
    Last post by neilv
  • Opto sensors
    by nosomis »
    8 Replies
    3683 Views
    Last post by Dreide
  • Missing printable parts for 2.0
    by Mellin »
    0 Replies
    2892 Views
    Last post by Mellin
  • Hot-end isolation peek gets melted
    by mmurin »
    1 Replies
    2835 Views
    Last post by Jaanus
  • extruder temperature sensor
    by cx32 »
    2 Replies
    3042 Views
    Last post by cx32
  • Stepper not working-connector? Electrical board?
    by Caliprint »
    4 Replies
    3352 Views
    Last post by sajjad123
  • ViKi LCD - How To Connect to Felix 2
    by mrlate »
    1 Replies
    2739 Views
    Last post by Makron
  • nozzle spec question
    by cstead »
    1 Replies
    2739 Views
    Last post by cstead
  • Extruder does not react
    by immi1988 »
    4 Replies
    816 Views
    Last post by immi1988
  • Felix 3.0 controller not printing
    by kellsteinman »
    3 Replies
    902 Views
    Last post by kerog
  • Heaters decoupled
    by Retrofire »
    4 Replies
    3519 Views
    Last post by kerog
  • Hot end fell out
    by slave »
    4 Replies
    834 Views
    Last post by viljmak
  • printer freezes when opening/closing light switch
    by Hugues »
    12 Replies
    1793 Views
    Last post by WayneC
  • Where can I buy the plastic hot-end heat separator?
    by satoer »
    6 Replies
    2588 Views
    Last post by JohnK1
  • Warped box
    by tomasf »
    1 Replies
    627 Views
    Last post by tomasf
New Topic

Forum permissions

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum