Page 1 of 1

Qualty of printed objects is getting bad (Felix 3.0)

Posted: Sat May 27, 2017 1:44 pm
by Regenmacher
Hello,
unfortunately the results of my printer are lately getting worse. The individual layers appear to be slightly offset.
I already have the straps stretched, everything is cleaned and lubricated.

None of this helped.

Does anyone have a tip?

Greeting,
Manfred

Re: Qualty of printed objects is getting bad (Felix 3.0)

Posted: Mon May 29, 2017 4:44 pm
by Dreide
I recommend checking the set screws of the pulleys (X and Y) and, while you are at it, also the set screws of the Z spindle and the extruder drive.