Page 1 of 1

Z-axis jumps up and down

Posted: Fri May 31, 2013 1:15 pm
by Mayhem
Any idea why bed goes up and down at certain point? Or is that normal?
http://youtu.be/xXNoTJ93HBM

Re: Z-axis jumps up and down

Posted: Sun Sep 08, 2013 3:42 pm
by kimmoli
What slicer/profile did you use?

Re: Z-axis jumps up and down

Posted: Sun Sep 08, 2013 7:35 pm
by Bachgassenbande
Reract enabled?
If using the repetier host and SFACT is default on.
So everything ok!