Page 1 of 1

Warped box

Posted: Fri Aug 15, 2014 10:28 am
by tomasf
Hi all,
My Felix printer has started to warp the printing in y-axis.
Attached you find a simple drawing explaining the problem.
My printer is a v1.5 upgraded to v2 ( still with the old PCB-board ).
Belts a tensioned correctly, every bolt checked.

Anyone got a clue how to adjust the printer back to correct working again ?

BR/tomasf

Re: Warped box

Posted: Tue Aug 19, 2014 1:54 pm
by tomasf
Hi All,
Guillaume has respond to my problem.
This is typically when the rail of the y-axis is not perpendicular to the rail of the x-axis. When loosening the 4 bolts of the y-axis rail in the z-axis lift part, you can slightly rotate the rail and test it again.
Another thing could be that the y-axis belt is worn


His suggestion to check/adjust the y-axis rail turned my printer back to perfect printing results again.

Thanks Guillaume !
BR/tomasf