Page 1 of 1

SFACT and hollow parts

Posted: Mon Nov 26, 2012 4:56 pm
by stratogavster
Hope somebody has covered this little challenge before....

How do I configure SFACT to fill a hollow shell? (in the hope it allows the subsequent 'roof' to build properly)

:D

Re: SFACT and hollow parts

Posted: Mon Nov 26, 2012 8:55 pm
by satoer
SFACT => Configure => Fill => Infill Solidity (ration): 0
(Now you get no fill at all)

Or do you want a solid object?
Maybe with the support settings? Add everywhere, if flatter than 90 degrees,

Re: SFACT and hollow parts

Posted: Mon Nov 26, 2012 9:42 pm
by stratogavster
Actually after a correctly printed part which in CAD is hollow.....but the roof of the part in theory will never print.....so happy for the core to be filled with SFACT, it's just knowing how to configure it to give the 'roof' of a hollow part the best chance possible.