Page 1 of 1

Try to make object sketchup but don't work

Posted: Sat Jan 04, 2014 4:43 pm
by martingaud
Hi everyone!

I just purchased my felix 2.0 and I like it a lot!

I know a lot sketchup and try to get the .stl extension...

It work and don't work... so I transfer to .obj, take it to another software (desingspark mecanical 1.0) and transfer it to .stl...

The big problem was the proportions.... in sketchup the object mesurement is 0.378" and in the felix repetier host it was to big for print.....

Do you have a free software to suggest ???

Thanks a lot!!!!!!!!!!!!!

Re: Try to make object sketchup but don't work

Posted: Sat Jan 04, 2014 4:49 pm
by Mayhem
Download stl plugin for the sketchup and then you can export stl.

Re: Try to make object sketchup but don't work

Posted: Sun Jan 05, 2014 12:41 am
by martingaud
It's done, everything work... Look at my desktop you will see that the ''newcube'' is a .stl file that I downloaded and skipole is a .stl created by sketchup.......It look like it wasn't .stl....
.stl trouble.JPG
.stl trouble 2.JPG