Slowing Down Print Speed in SFACT

[stiffmasters]

Hi everyone,

I've been printing very successfully for a few months with PLA using the standard SFACT profiles. However, i've ordered some Ninjaflex filament and it's recommended to slow down the print speed to about 25-35%. I've had a look around the SFACT profiles (and to be honest I'm not sure what most of the settings do) and I've read the SFACT manual and it seemed to go over my head.

Is there a way to simply slow down the whole print, without having to tweak flow and feed rate for each section of SFACT?

Any help is much appreciated!

Thanks
Jason

[Makron]

set this lower and it will print slower. haha

[Saamec]

[stiffmasters]

Wow, that easy huh! Thanks mate!