Page 1 of 1

Stop printing.....

Posted: Fri Apr 25, 2014 10:43 pm
by Saamec
Faced with the following problem. Flooded new firmware Repetier and now if the printer is not used in the sense I don't give him any commands, then he turns off the power. Does any timer. This leads to the fact that printing stops after a power outage. Don't know where to fix it in the firmware? :?: :roll:

Re: Stop printing.....

Posted: Sat Apr 26, 2014 9:34 am
by Bitpower
Same problem here, disconnect and reconnect repetier solves the problem.

Printer goes into sleep mode?

Re: остановка печати.....

Posted: Sat Apr 26, 2014 10:55 am
by Saamec
the problem is that it goes into sleep mode when active seal.... on a layer of 100 turns the power off

Re: остановка печати.....

Posted: Sun Apr 27, 2014 10:11 am
by Saamec
Thanks for the answers)) there were many of Them and all of the case the problem is solved by setting the EEPROM:
Printer active [s] = 0
Max. inactive time [ms,0=off = 0
Stop stepper after inactivity [ms,0=off = 0

Thanks, that helped... I had to understand everything yourself... use.