Page 1 of 1

Can't heat extruder and printbed

Posted: Wed Apr 10, 2013 8:21 pm
by markus_kyroe
Hi Guys,

I have had some problems with my printbed lately. After a few layers it turned off. To fix this I tried to update the software and firmware.

This seems to have ruined everything :roll:
When I run Repetier Host I have no problems with controlling the axis but when I try to heat either printbed or extruder I run into problems - none of them will heat!

I have tried to uninstall, clean registries, re-flash and reinstall software but nothing seems to work.

What to do? Can it be a hardware problem? Please help :idea: :D

(Still runnning the Felix 1.0 Revision E and can't wait for an update to the new 2.0!!!)

Thanks in advance,
Markus

Re: Can't heat extruder and printbed

Posted: Wed Apr 10, 2013 8:32 pm
by killejano
Have you tried to format the arduino? Or try loading something else into it and then the newes version firmware. Does the airduct fan react to commands?

Re: Can't heat extruder and printbed

Posted: Wed Apr 10, 2013 9:06 pm
by markus_kyroe
Have tried to load the arduino with both the old- and the new format. Have also tried the newest firmware.

The airduct fan is dead too...

Re: Can't heat extruder and printbed

Posted: Sat Apr 13, 2013 3:17 pm
by markus_kyroe
It is even worse now...

Can't move the axis. Motors are making noise and nothing happens.

Totally dead printer. Any clues?