Page 1 of 1

Bed Leveling help-file

Posted: Wed May 08, 2013 8:15 pm
by angryangel
Hi

this bed-leveling-help i found on thingivers but it dosent work with the original file because the felix have an other bed size

so i made i simmiler one that fits better to the bed of ouer felix printer

today i tested it

i just printed and mesured the layer hig at different positions and after that i adjusted it and print again until the layer high was the same at evey position for me it worked very good

perhaps it helps someone too

her is the link to the original
i do not really understand the instruktions for my file i juste used the normal settings and mesuered as discribed above

http://www.thingiverse.com/thing:15709

my fil is just one layer high and wide