Unstable hot end temperature?

Post Reply
andrewsi
Posts: 130
Joined: Mon Dec 23, 2013 1:26 am

Re: Unstable hot end temperature?

Post by andrewsi »

From your early pic where it looked like the thermistor is sticking out of the hot end, that could correspond with the 2nd fan blowing on it and making it think it's too cold. Might be worth seeing if there is a way to get it to be more fully inserted.
__________________________________________
Andy Silverman, Technogeek in Seattle
Felix Tec4 Single-head

Bachgassenbande
Posts: 132
Joined: Sat Jul 20, 2013 12:50 pm
Location: Würzburg

Post by Bachgassenbande »

Try to turn the fan off and see what happens then, no need to push in the thermistor more to verify
Felix 2.0
E3D Kraken Hotend
3mm Glas bed
LED light bar upgrade

Dreide
Posts: 176
Joined: Sun Sep 29, 2013 12:32 am
Location: Lausanne, Switzerland

Post by Dreide »

Meanwhile I worked on my hot end. I pulled out the thermistor and measured the hole, which turned out to be just about 5mm deep, so I decided to drill it all the way through. I put the thermistor back in and sealed it with high temp silicone. Now the temp curve looks like this:
Temp curve (after fix).png
... at a different temp scale:
Temp curve (after fix, zoomed).png
The snapshot was taken during a print of a rather big part and begins at layer 10 or so. The 2nd fan was running at different speeds for the perimeter and the infill. I noticed that the temperature noise level goes somewhat up at higher layers which I think is caused by the cooler air up there due to the increased distance to the heated bed.
So, problem solved I guess.
Felix 2.0->3.0dual * Repetier (host+firmware) * KISSlicer Pro, Simplify3D * Cubify Design

Post Reply

Return to “Troubleshooting”