1.5 --> 3.0 Power supply fan

Discussions about the electronics
Post Reply
Posts: 2
Joined: Mon May 26, 2014 12:48 pm

1.5 --> 3.0 Power supply fan

Post by ebiz@centrum.cz »


i just upgrade from 1.5 board to v2.1

All looks fine except:

1. opto sensors leds wont light
2. hot end is heated more than is wanted. If i setup 200C it gets 225C..
3. When hot end and bed is heating, and bed goes up to 45C, fan on the power supply goes loud and
in a second is turned off and on and off and on...... is that normal?

many thanks David

*really love mine Felix! thank you!*

Post Reply

Return to “Electronics”