Skeinforge Support Settings

Discussions about firmware/slicing software, tweaks and settings
Post Reply
kerog
Posts: 117
Joined: Mon Jun 09, 2014 1:54 am

Skeinforge Support Settings

Post by kerog »

I've found that with the default settings that come with the printer, the support material is much to solid and hard to remove. Has anyone experimented with the Skeinforge settings and found something that works well for the the Felix 3.0, providing easily removable supports?

-Keith

User avatar
gfeliksdal
Site Admin
Posts: 405
Joined: Sat Feb 25, 2012 10:40 pm
Location: Netherlands
Contact:

Post by gfeliksdal »

Hi Keith,

Please check here in the sfact configuration:
2014-07-25_082902.jpg
2014-07-25_082626.jpg
Kind regards,

Guillaume

Post Reply