cura advantages/problems

Discussions about firmware/slicing software, tweaks and settings
Post Reply
cstead
Posts: 3
Joined: Fri Jul 04, 2014 1:33 am

cura advantages/problems

Post by cstead »

Well I have been searching for better slicing options than the standard repetier options,
tried kisslicer then Cura..... all I can say is WOW on the speed of cura and the simplicity.

I run the slicer then save/export to my desktop and open it in repetier,I love the control panel
and control of it.
The problem is that on a cylindrical object the printer will act ratchety on the perimeter or any
rounded edge
Just wondering if anyone had run into this problem and if had ever been resolved for them?

I inquired this problem on the cura borads but it has not particularly helped....here is a link
http://umforum.ultimaker.com/index.php? ... nt-action/

Post Reply