Step 22. Z carrier distortion

Help eachother out with assembly problems.
Post Reply
RAD Design
Posts: 3
Joined: Fri Aug 08, 2014 11:12 am

Step 22. Z carrier distortion

Post by RAD Design »

Hi,

Step 22. Cannot get Z carrier to fit onto the cart of Z axle rail. Z carrier moulding appears to have distortion. At the end with spindle nut, measurement is 32.5mm which fits onto cart fine. Opposite end measures only 31mm and will not fit over cart.

Any advice would be great.

Thanks.

kerog
Posts: 117
Joined: Mon Jun 09, 2014 1:54 am

Post by kerog »

As I recall, I had the same problem. I believe I just put the end that fit in first and then used a lot of strength to get the other end on. It took several tries.

Post Reply