Extended filament arm

This is the place to show off your felix printer hacks and improvements.
Post Reply
Posts: 150
Joined: Sat Dec 28, 2013 6:07 pm

Extended filament arm

Post by frankjoke »

Dear all,
you can find in the download area a filament_arm_test_v5.stl which I liked very much but it was too short for some of my spools.

As I had only the STL I used SCAD to extend it by 2cm (scaling it would not work because it would scale also the part which need to fit into the printer).

Attached in Zip are the original STL from Felix, the SCAD file and the modified STL.

Enjoy :)
Filament Arm Long version
(470.68 KiB) Downloaded 89 times

Post Reply

Return to “Hacks and printer upgrades”