Trapezium spindle with diferent parameters

Discussions about mechanics
Post Reply
Tygrik
Posts: 38
Joined: Tue Jun 19, 2012 12:17 pm

Trapezium spindle with diferent parameters

Post by Tygrik »

Hello,
I have a problem. I replaced the Trapezium spindle for different parameters TR10x3. The original is TR10x2. With this action does not correct step the Z axis.
Where can I change this parameter and how?

Thank you

Makron
Posts: 110
Joined: Wed Mar 20, 2013 1:29 pm

Post by Makron »

In the firmware tab Configuration.h

Look for

#define DRIVE_SYSTEM 0
#define XAXIS_STEPS_PER_MM 76.19999
#define YAXIS_STEPS_PER_MM 76.19999
#define ZAXIS_STEPS_PER_MM 1600

Change
#define ZAXIS_STEPS_PER_MM 1600

To
#define ZAXIS_STEPS_PER_MM 1066.67

That should work.

I used http://prusaprinters.org/calculator/ for that valeu

Tygrik
Posts: 38
Joined: Tue Jun 19, 2012 12:17 pm

Post by Tygrik »

thank you very much, in the evening try to change this parameter

Makron
Posts: 110
Joined: Wed Mar 20, 2013 1:29 pm

Post by Makron »

I forgot there is an easy way to do this.
Attachments
change.png

Tygrik
Posts: 38
Joined: Tue Jun 19, 2012 12:17 pm

Post by Tygrik »

Hello,

Im test firts yours help and work it.

Thank you very much

Post Reply