electronics board

Discussions about the electronics
Post Reply
hvdweerd
Posts: 26
Joined: Mon Sep 30, 2013 10:48 am
Location: Netherlands

electronics board

Post by hvdweerd »

Hi,

Last week, I changed the heater cartridge for this http://reprapworld.com/?products_detail ... =1616_1671
This heater is 40W.

The same time I have 'updated' the firmware back to Marlin (Felix 2.0)

Now, the stepper motors doesn't turning yet.
Hopefully, my electronics board is not damaged.

1. This problem, is it firmware based or hardware based?
2. What is the power of the Felix heater cartridge?

Makron
Posts: 110
Joined: Wed Mar 20, 2013 1:29 pm

Post by Makron »

volgens mij heeft dat niet veel te maken met de heater .

Krijg je wel een temperatuur ?
lijkt me meer dat die kapot zou kunnen zijn.

Kuupeetje@gmail.com

hvdweerd
Posts: 26
Joined: Mon Sep 30, 2013 10:48 am
Location: Netherlands

Post by hvdweerd »

Heater is still working.
But I can't home the x, y, z axis

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

Have you tried re-flashing it with the original Felix 3.0 firmware? Then you know for sure its a firmware problem if it works again.

Why do you want to go back to Marlin?
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

hvdweerd
Posts: 26
Joined: Mon Sep 30, 2013 10:48 am
Location: Netherlands

Post by hvdweerd »

Hi satoer,

Yes, yesterday I have updated to the .92 version. Is is working correctly now.

With marlin, I can change the filament (while printing)

hvdweerd
Posts: 26
Joined: Mon Sep 30, 2013 10:48 am
Location: Netherlands

Post by hvdweerd »

Problem is solved, it was a firmware problem.
Thanks for support.

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

Why can't you change the filament while printing? Doesn't the "pause job" work? The output port configuration must be different with the Arduino+RAMPS and the Felix board. Just compare the configuration.h file to make the Felix board compatible with Marlin.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

hvdweerd
Posts: 26
Joined: Mon Sep 30, 2013 10:48 am
Location: Netherlands

Post by hvdweerd »

Yes, the "pause job" doesn't work.

Normally, I use next code for filament change. How can I change it?


G91
G1 E-2 F1800
G1 Z10 F300
G28 Y0
G28 X0
G1 E-68 F2000
M0
G1 E30 F1000
G1 E40.2 F200
G1 E-0.2 F500
G90
M0

hvdweerd
Posts: 26
Joined: Mon Sep 30, 2013 10:48 am
Location: Netherlands

Post by hvdweerd »

???

Post Reply