Does 3.0 Work with 2.0?

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
JasperCocquyt
Posts: 2
Joined: Thu Nov 27, 2014 11:16 am

Does 3.0 Work with 2.0?

Post by JasperCocquyt »

Hello, i have a school project where i have to build the FELIXprinter 2.0 i've found the manual for building the printer, but for the software (the rep rap) it's all for the 3.0 version at least that's what i found. i've only just recieved the pakkage and done some research on how to start the build and what software i have to get so i could be i'm a little to hasty with looking. sorry if my questions are a bit stupid but thanks for the answers.

Dreide
Posts: 176
Joined: Sun Sep 29, 2013 12:32 am
Location: Lausanne, Switzerland

Post by Dreide »

Firmware-/software-wise the 2.0 is identical to the 3.0 (single extruder).
Felix 2.0->3.0dual * Repetier (host+firmware) * KISSlicer Pro, Simplify3D * Cubify Design

JasperCocquyt
Posts: 2
Joined: Thu Nov 27, 2014 11:16 am

Post by JasperCocquyt »

Thanks!

Post Reply