Which Extruder is it?

Help eachother out with assembly problems.
Post Reply
jjlink
Posts: 30
Joined: Thu Nov 27, 2014 4:45 pm
Location: California, USA

Which Extruder is it?

Post by jjlink »

Can anyone tell me if extruder number two on the left or the right side (when looking from the fan side)?

Also I can't seem to get them the same height from the base. The screw adjustments don't seem to help.

Thanks!
Felix 3.0 with E3D Dual direct drive extruder conversion. (http://forum.felixprinters.com/viewtopic.php?f=9&t=1630)
Software: simplify3d

gillespinault
Posts: 10
Joined: Sun Mar 16, 2014 9:50 am

Post by gillespinault »

Hello jjlink,
extruder number two is on the right when facing the fan.

I have the same problem with height adjustment. The closest I got was with screwing screwing slightly tighter the hotend in the peek for the lowest extruder of the two.

If someone has a better way to do it,I'm interested in the answer too.

jjlink
Posts: 30
Joined: Thu Nov 27, 2014 4:45 pm
Location: California, USA

Post by jjlink »

Thanks, I suspected I had the two extruders cross wired. I reversed them and now they are correct.

I did get the height on the extruders to match by loosening the fan bolts a bit and pushing up on the low extruder and pulling down a bit on the hight one. They are both level now on the base.

Now I am having issues feeding the pla into E1. I suspect its clogged because the pla will only go in a bit then stop.
Felix 3.0 with E3D Dual direct drive extruder conversion. (http://forum.felixprinters.com/viewtopic.php?f=9&t=1630)
Software: simplify3d

Post Reply