SFACT and hollow parts

Discussions about firmware/slicing software, tweaks and settings
Post Reply
stratogavster
Posts: 120
Joined: Tue Jul 17, 2012 9:04 pm
Location: United Kingdom

SFACT and hollow parts

Post by stratogavster »

Hope somebody has covered this little challenge before....

How do I configure SFACT to fill a hollow shell? (in the hope it allows the subsequent 'roof' to build properly)

:D

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

SFACT => Configure => Fill => Infill Solidity (ration): 0
(Now you get no fill at all)

Or do you want a solid object?
Maybe with the support settings? Add everywhere, if flatter than 90 degrees,
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

stratogavster
Posts: 120
Joined: Tue Jul 17, 2012 9:04 pm
Location: United Kingdom

Post by stratogavster »

Actually after a correctly printed part which in CAD is hollow.....but the roof of the part in theory will never print.....so happy for the core to be filled with SFACT, it's just knowing how to configure it to give the 'roof' of a hollow part the best chance possible.

Post Reply