Sfact Build Log

Discussions about firmware/slicing software, tweaks and settings
Post Reply
packman
Posts: 8
Joined: Sat Sep 22, 2012 2:02 am
Location: Cedar Grove, New Jersey, USA
Contact:

Sfact Build Log

Post by packman »

I have noticed something in the build log of the Sfact slicer. When I scroll up there are two lines that mention Tkinter. One says " <skein forge> warning skeinso will do nothing because Tkinter is not installed". The other says "<skein forge>warning skein layer will do nothing because Tkinter is not installed". I researched Tkinter, it is a plugin for skein forge. Do we need this? Ernie

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

Tkinter is only necessary to view the sliced model if you use the slicer stand-alone. Since repertier host had his own 3D viewer, Tkinter isn’t necessary.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

packman
Posts: 8
Joined: Sat Sep 22, 2012 2:02 am
Location: Cedar Grove, New Jersey, USA
Contact:

Post by packman »

Thanks for your answer. Repertier is staight forward and easily learned. It seems that learning to make better use skein forge will improve my building results.

gobi
Posts: 52
Joined: Sun Sep 09, 2012 1:05 pm
Location: Hungary

Post by gobi »

i want to find the log file for sfact. to see all the prints, hours etc. does it keep any record and if yes then where can i find it?

Post Reply