What is the largest layer height one could use to get decent prints at speed = 80mm/s (or lower) ?
So far, I only printed with 0.25mm or 0.2mm or 0.25mm using half-layers (SKIN in SFACT)
Any opinions or experiences to share ? In particular using both fat layers + SKIN
- Daniel
PS: I'll try 0.35 or 0.4 sometimes (with various SKIN combinations)
layer height
Moderator: speedake95
-
- Posts: 49
- Joined: Thu Apr 12, 2012 3:29 pm
- Location: Geneva
- Contact:
Technically, since the nozzle diameter is 0,35 mm, I don’t think you should go higher than 0,35mm. But I haven’t tried it though…
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix