How to change a thermistor

Discussions about the electronics
Post Reply
bulke
Posts: 5
Joined: Tue Dec 16, 2014 12:02 pm

How to change a thermistor

Post by bulke »

Hi,
I have a DIY assembled Felix 3.0 but unfortunately I didn't assemble myself.
Now the thermistor is broken and I want to change it.
Tried to pull it out gently but it doesn't work
Any hints?

Thanks
Nikola

bulke
Posts: 5
Joined: Tue Dec 16, 2014 12:02 pm

Post by bulke »

I found a small screw below the thermistor.
I guess i schould lose it a little bit as soon as I find a <=1mm hex key :)

Nikola

cx32
Posts: 12
Joined: Fri Jan 03, 2014 11:40 pm

Post by cx32 »

My extruder temp sensor started to have erratic readings, jumping 10-20c above and below the temperature set temperature.

Question, where can I find another temp sensor (NOT from Felix).

Felix has an e30 minimum order and shipping for an e34 order was e37 - over e71 total!!!
Do live almost on the other side of this planet from them in USA, California but e37 just for shipping!!!

Post Reply