Extruder does not heat up

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
Posts: 1
Joined: Sat Dec 27, 2014 11:31 am

Extruder does not heat up

Post by F3DSB1 »

I've just bought a Felix 3.0 printer single head DIY kit.
After assembling the printer, wich worked out perfectly i started up the configuration
with the repetier software.
The display on the printer showed Felix 2.0 ready.

After calibrating i tried to start printing but the extruder does not heat up.
The led on the circuit board lights up but the heater cartridge does not heat.
Since it is brand new i dont think this part is broken.

Does anyone had this similar problem and how do you fix this??

Also uploading 3.0 firmware fails when i try to upload it with Arduino software.

Post Reply

Return to “General”