putting bearing balls back into bearing set

Help eachother out with assembly problems.
Post Reply
neep
Posts: 19
Joined: Sun Jan 04, 2015 12:45 pm

putting bearing balls back into bearing set

Post by neep »

Hi all, I'm assembling my Felix 3.0 today, and I made a stupid mistake.

At step 29, because the picture showed me that I had to tilt the frame that way, I did, and the bearing set slid off the rails. 3 bearing balls fell out! I am trying to put them back but can't manage.

Has anyone had this happen? If so, how to fix?

Please help!

Thanks.


P.S. to the makers of the assembly manual: you should change the orientation of the picture in step 29. This is misleading!

Post Reply