Extruder motors not responding

Help eachother out with assembly problems.
Post Reply
seaton
Posts: 291
Joined: Tue May 14, 2013 9:04 am
Location: Bunbury, Western Australia
Contact:

Re: Extruder motors not responding

Post by seaton »

I'm assuming single extruder?

have you tried with it wired into other extruder channel on the board? also the pot is it set as per manual and not turned all the way down?

may be a problem with the stepper output channel, you could try swapping on the board and in firmware to the secondary one to test
Stephen...

Felix 2.0 -> Felix 3.0 dual
Simplify3D Slicer, Kisslicer
Have you added your Felix to the Map? http://goo.gl/maps/HajnZ

http://blog.strobotics.com.au

Post Reply