TPU printing

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
rickconterra
Posts: 1
Joined: Tue Jan 27, 2015 12:42 am

TPU printing

Post by rickconterra »

Has anyone had any luck Printing with TPU material? I cannot get it to feed through the hot end ( Felix 2.0). I am heating the extruder to 240 C and advancing the filament very slowly as per the manufacturers instructions, but nothing comes out the end. Printer runs fine all day long with PLA and ABS.

Thoughts?

User avatar
DDME-Marc
Posts: 71
Joined: Sun Nov 24, 2013 11:04 pm
Location: New Zealand

Post by DDME-Marc »

Hi Rick,

NinjaFlex is part of the TPU (thermoplastic polyurethane) family.

Several post have been made on this forum regarding NinjaFlex regarding feed control and settings etc.

http://forum.felixprinters.com/viewtopi ... flex#p5773


Cheers,

Marc
Felix 3.0 Dual Head * E3D Titan V6 * Repetier-Host V2.1.3 * Repetier-Firmware 0.92.9 (01/08/17 - Modified) * KISSlicer Pro - 1.6.3 * Arduino 1.8.5 *

Post Reply