Y-Motor pushes through Y-OptoSensor

Discussions about mechanics
Post Reply
evanr
Posts: 101
Joined: Thu Nov 29, 2012 3:09 am

Re: Y-Motor pushes through Y-OptoSensor

Post by evanr »

I took the bed off and exchanged the Y-Opto for the X-Opto.
- "new" X-Opto: still works great when homed.
- Y-Home: Y-Motor still doesn't stop when it reaches the new exchanged Y-Opto.

So far:
- wiring and opto-sensor options considered ruled out.
- I've also pushed the reset button on the Ramps.
- thought maybe an overheating issue, so tested at start up.
- replaced tape on vane with tin foil
- re-uploaded firmware to Ramps
- checked for updated VCP drivers

If this is indeed a firmware issue, how would I resolve this?

I don't know what else to do.
Any help appreciated.

hvdd
Posts: 71
Joined: Tue Jul 24, 2012 11:43 pm

Post by hvdd »

seems the same problem that i had in the beginning.
i swapped xand y stepper plugs on board and also sensor plugs on board to isolate the problem.
still Y was not working.
swapped the little driver pcbs to find out ... still the same problem.
maile felixprinters and solution was Marlin revision E !
downloaded flashed problems solved.
on startup or reset you can see the flashed version on screen ( answer from printer to pc)
just my story
rgds

evanr
Posts: 101
Joined: Thu Nov 29, 2012 3:09 am

Post by evanr »

thanks hvdd.

I updated the software with Repetier Host 7.0c and firmware with Marlin RevD.

Y-Axis is ok now.

I liked the features of Repetier 82b and Marlin RevE, but in the end its gotta work.

You can find out more about this thread in - No control after "Home" button (solved) - by wdieckmann

I haven't tested firmware Marlin RevD with software Repetier 82b

evanr
Posts: 101
Joined: Thu Nov 29, 2012 3:09 am

Post by evanr »

Has anyone tested Marlin RevD with software Repetier 82b?

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

I'm running RevD with the latest Repertier host V0.82. No problems.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

Post Reply