Christmas Tree

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
dognotdog
Posts: 181
Joined: Tue Sep 04, 2012 9:22 pm

Christmas Tree

Post by dognotdog »

:)

Image
xmas tree.STL
Christmas Tree STL
(817.27 KiB) Downloaded 26 times
As slicing takes ages, also some gcode:
xmas1.gcode
Christmas Tree gcode 30mm/s
(9.78 MiB) Downloaded 30 times
PS: best printend upside-down.

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

Upside down? That's a very adhesive printbed you've got!
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

dognotdog
Posts: 181
Joined: Tue Sep 04, 2012 9:22 pm

Post by dognotdog »

Hehe, or... the STL contains the support structure :)

Kjetilei
Posts: 334
Joined: Fri Mar 16, 2012 8:26 pm
Location: Stavanger, Norway

Post by Kjetilei »

Nice!

I was a little bit baffled about the upside down part :)

Post Reply