Can someone confirm - is:
20141208 - FIRMWARE - Repetier 0.92 - FELIX_3_0_SINGLE_extrusion.zip
relevant to Felix 2 units ?
If so, maybe the file name could be more general ?
If not, are there any further firmware upgrades for older models such as the Felix 2 ?
Thanks
is the v0.92 firmware relevant to Felix2 models?
-
- Posts: 49
- Joined: Sat May 10, 2014 2:54 am
I believe there are no mechanical changes between the 2 and the 3. Same pinions on the extruder, X and Y. Same spindle on the Z. And same electronics... So I guess It should work fine. Just keep a copy of the old firmware before upgrading. You can always downgrade. And, if there where hardware changes you can always re-calibrate and store it in the EEPROM. (accessible through the “Firmware EEPROM configuration” in the configuration menu from Repetier host.)
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix