extruder motor noisy

Post Reply
iddconcept
Posts: 3
Joined: Sat Feb 21, 2015 1:17 am

extruder motor noisy

Post by iddconcept »

some time during print the extruder motor make toc toc at certain place

last week the after sale service of my provider replace this motor because no extrusion due to a break wire, but it work except sometimes this toc toc

any idea

fesch
Posts: 35
Joined: Fri Dec 05, 2014 11:14 pm
Location: Luxembourg
Contact:

Post by fesch »

Sounds like not enough power is being offered to the motor?

satoer
Posts: 436
Joined: Mon Oct 01, 2012 8:00 pm
Location: Netherlands

Post by satoer »

Your stepper motor is skipping steps. I'ts discussed several times before, If you search for "skipping" you probably find the solution.
My Felix 1.5 printed designs on Thingiverse
E3D V6 Hot end upgrade for your Felix
Tweezer bracket for your Felix
Led bar upgrade for your Felix

Post Reply