Have been able to establish connection through Repetier-Host Mac 0.56. Status in Repetier reads "Unknown printer firmwareWaiting for temperature."
5 commands are waiting and I can't clear these by resetting the board.
Printer firmware is Repetier 0.922 and VCP drivers are 2.2.18.
Screenshot of printer settings in Repetier are attached.
Relevant output from dmesg dump follows below.
Code: Select all
0 [Level 5] [com.apple.message.domain com.apple.commssw.ftdi.device] [com.apple.message.signature AppleUSBFTDI] [com.apple.message.signature2 0x403] [com.apple.message.signature3 0x6001] [com.apple.message.summarize YES] AppleUSBFTDI: Version number - 1.0.1b12, Input buffers 8, Output buffers 16 40164 39fbc AppleUSBFTDI: calculateDeviceBaud - Baud rate error 0 0 AppleUSBFTDI: setBaudRate - calculateDeviceBaud returned bad baud rate USBMSC Identifier (non-unique): 13062853000989 0x18a5 0x302 0x100, 2 200b20 1cfde0 AppleUSBFTDI: calculateDeviceBaud - Baud rate error 0 0 AppleUSBFTDI: setBaudRate - calculateDeviceBaud returned bad baud rate