Can you share small and complex model's secrets, guys ?

Moderator: speedake95

Post Reply
Boris
Posts: 45
Joined: Thu Jan 15, 2015 11:59 pm
Location: Moscow
Contact:

Can you share small and complex model's secrets, guys ?

Post by Boris »

MAIN problem for me is wraping ABS when cooling down. It' causes not flat top if surfaces and sometimes hotend breaks the supports or small details in tiny or complex models.

The some kind of solution was "Retraction Vertical Lift" option in Simplify 3d.
So, it means before any trace Felix pull down bed for 1mm, then trace to position and push it up again to hotend.

It takes a time, a lot of time but result is well :) no broken supports or small details.

What do you guys to print very detailed models ?
Tell about your experience, please.

Model below is ABS, 12cm tall, fingers is 1mm
printed in 0.150 precision
Attachments
baccg5erNx8.jpg
MtJ9T5MXEIo.jpg
OgAS0J461VA.jpg
Felix 3.0 x2 extruders

Post Reply