Gcode pause and start through lCD control?

Discussions about firmware/slicing software, tweaks and settings
Post Reply
wilco02
Posts: 8
Joined: Sat Mar 14, 2015 6:39 pm

Gcode pause and start through lCD control?

Post by wilco02 »

Is there also an option to use a M Code(Pauze) in the program and that you can resume the program through the control of the LCD screen. Because i want to make an small adjustment program for leveling the bed. Now i use the G4 Dwell function it works but not really handy.

So hopefully this is possible.

Thanks.

Wilco.

Post Reply