I have a felix 3.0. When the print head is moving back and forth in the x axis (i.e. a tall skinny part) The relative offset is not correct - like the motor or belt is slipping so I get a double image after a few layers and following layers are off by a cm or more. I have tried setting a lower speed on slice, increasing the tension of the x-axis belt, and tightening the set screw on the motor gear.
This happens on all prints. Any advice would be great.
Thanks,
Tim
Printer offset in x-axis is wrong
-
- Posts: 2
- Joined: Tue Jan 05, 2016 1:49 am
I believe the x-axis belt was too tight. I loosed it up and it is now working fine