Cura Engine Perimeter-Loop-Infill order

Discussions about firmware/slicing software, tweaks and settings
Post Reply
Posts: 8
Joined: Fri Sep 27, 2013 2:13 pm

Cura Engine Perimeter-Loop-Infill order

Post by stiffmasters »

Hello all,

I'm experiencing bubbling overhangs and uneven walls, and believe it to be because by default the Cura slicer is printing in this order:

Loop - Perimeter - Infill

Does anyone know how to change this order in the cura settings in Repetier Host? I know it can be done in SFact, but I've moved away from that because of Cura's slicing superiority. I'd like to change the order to:

Perimeter - Loop - Infill

Any help is much appreciated!

Many thanks

Post Reply

Return to “Software/Firmware”