General question about printing

[pegazus80]

Hey forumers!

I have a basical question but I think its better to ask like doing something crazy
Is it possible to slice a part than print the bottom part of that than later print the top part of the object without moving the first one from the bed.
I would place some metal parts in my print (these will not be higher than the top layer as the first part so the hot-end can't stock) than finish my object.
If this process possible what do I need to watch?
Thank you for your help in advance

[Bitpower]

Pause

http://www.repetier.com/documentation/r ... de-editor/

[pegazus80]

I tought to this solution too but I have to stop the printing at very exact places so this is why I tought for the slice.
Sometimes if I pause the print it continues till finish a pack of work so I can't keep my exact slices

[venkel]

Model it in two parts. First part normal printing, second part with the slicer option to start with a certain distance from the bed.
I would prefer the pause option, but the above should work.