how adjust extruder 2?

General discussions regarding hardware
Post Reply
Posts: 4
Joined: Sun Feb 14, 2016 10:41 am

how adjust extruder 2?

Post by otzelot »

Hello everyone!

I have bought a used Felixprinter 3.0 with upgrade to 3.1 dual extruder.
When i adjust extruder 2 to the same level hight (0.15mm above heatbed) as extruder 1 , often the extruder 2 destroys the printed lines..... what is wrong with that? have i to adjust extruder 2 higher than extruder 1 ?

Thanks in advance!

Greets Ralf

Post Reply