Z-axis limit switch position

Help eachother out with assembly problems.
Post Reply
daveinhull
Posts: 66
Joined: Fri Jan 11, 2013 2:31 am

Z-axis limit switch position

Post by daveinhull »

Hi

On page 14 of the V1-20-Oct-12 manual, it tell you how to build the z-axis limit switch and says to mount it last so it doesn't get damaged.

However, when you get to the end of the mechanical construction (page 31) it has never been mounted.

I can see where it goes from the pictures of the final printer but I'm not sure how high or low it needs to be mounted on the vertical z-bean; I'm guessing somewhere near the top of the z-axis slider but a rough position from a reference point would be good.

Many thanks
Dave

picka
Posts: 11
Joined: Thu Aug 23, 2012 12:44 am

Post by picka »

If you keep reading on I believe it does say where to mount it and how to calibrate it. Should be in the finishing touches and calibration section (at least thats where is was in rev E)

daveinhull
Posts: 66
Joined: Fri Jan 11, 2013 2:31 am

Post by daveinhull »

Thanks Picka,

Yes seen it on page 42....

Post Reply