Discussions about firmware/slicing software, tweaks and settings
Post Reply
Posts: 1
Joined: Tue Feb 11, 2014 7:27 pm


Post by jezurender »

Hi, i use CURA from REPETIER and i have very good results. But, i see that SIMPLIFY3D have better results than cura, in any images from google. I want to know any settings to configure S3D from Felis Printers. (Actually i have S3D 3.0.2).
Thanks for your answers.

Posts: 17
Joined: Thu Dec 17, 2015 2:29 pm

Post by venkel »

These are mine. Pay attention to check settings, as the infill , support etc. need to be customized for each print.

One file for single extruder (choose left or right), the other for dual extruder operation. In the latter I added a tool change script, be sure to change the temperatures to appropriate values (it seems not possible to use variables in this case).

Good luck and keep me informed if things need improvement.

Post Reply