Controller Azteeg X3 + PCB heatbed

This is for general discussions. Also FAQ can be found here.

Moderator: speedake95

Post Reply
Posts: 10
Joined: Tue Oct 16, 2012 4:23 pm

Controller Azteeg X3 + PCB heatbed

Post by kerstens »


Let me know what your opion is on the following two components. Improvement or decline.

Is the Azteeg X3 controller a better controller for the felix printer then the Ramp 1.4?

Will a PCB Heatbed (Helios Heated Bed) be an better solution then the 4 heatpoints that we have now on the bed?

GRTZ kerstens

Post Reply

Return to “General”