Adjusting SFACT Profiles

Discussions about firmware/slicing software, tweaks and settings
Post Reply
Posts: 66
Joined: Fri Jan 11, 2013 2:31 am

Adjusting SFACT Profiles

Post by daveinhull »


I've actually started to get some prints with using the new Repetier version and SFACT slicer but the part is warping badly from the bed. IN another post someone suggested raising the temperate of the extruder for the first few layers and then reducing back to normal.

Could someone give me a clue as to where to start doing this in the SFACT configuration options?

Many thanks

Post Reply

Return to “Software/Firmware”